Sunday, August 6, 2017

HOMEWORLDS FIGURES

A little bit on Homeworld's Figures.
Series 1

All of Homeworld's figures are hand made.  While I may have the Master 3D printed,  Homeworld does not 3D print any of its parts.  In fact, some of the masters needed were so small they could not be printed and had no choice but to be made by hand.

Molds are made.  Casts are made.  Casts are sanded and holes are drilled.  Parts are washed and assembled.  Light detail painting and then clear coated.
 

All molds and casts are pressurized to 55 PSI.  Casting requires a minimum of 30 PSI to be effective.

Homeworlds figures are heavier than printed figures the same size.  My cast parts do not float in water.  I use water to help check my parts.  If a cast part floats,  its garbage.  It means it has an air bubble in it.

Series 1 and Series 2 figures have slight differences.  Series 1 figures feature a matching glider pack.

  Series 2 figures feature a missile pack in place of the glider pack.  Glider Packs have been phased out and are no longer available.
Series 2 figures now feature clear urethane shoulder pins.  A feature that will be permanent for all future figures.

All figures carry Homeworld's 90 Day Guarantee and Lifetime Warranty*

I know of no other Indy Toy maker in the world who offers this kind of guarantee. 

Im committed to making the best figure I can.  One that you will be proud to both own and display.


No comments:

Post a Comment